Room Divider - installed!
We first introduced you to this room divider project back in October. The client wanted the finish to “not look new”, so we decided to do a rust finish. After the fabrication was complete, the room divider was sandblasted, then hosed down with water and allowed to form a coat of surface rust.
the final product on the shop floor
close-up of the center header
Once complete, our final task – to carry this monstrous steel room divider up a stairwell to a fourth floor loft. Utilizing a crew of nine guys we literally took the room divider (remember, the middle section of this was over 9 foot tall and about 5 foot wide) about two steps at a time until we arrived at our destination on the fourth floor.
Here you see the crew setting up the pieces of the room divider in the loft
Happy in its new home